The box I made with Zach

The box I made with Zach

The box I made with Zach (full size)

Prev (1/6)

in Skate Box

This photo was taken in Ankeny, Iowa.

It's also on Flickr.

Photo Map
I've got 1,447 photos from this spot

comments

  • how long is it

    james posted

  • 6 ft

    derek posted

  • how tall?

    brandon posted

  • 8 inches like this. I also made a 6 inch booster to raise it up to 14 inches

    derek posted

  • where can you get angle iron from?

    Heinz posted

  • my dad and I are going to build one for scootering. will these plans work for a scooter box? Oh! And i would use it for my master bmx skillz. would the frame be able to sustain the weight of my 15pd. bike?

    Derek posted

  • yes and yes.



    we jump hard on this box all the time, it's very strong. we've had guys skating on this that range from 100-200 pounds.

    derek posted

  • i got both the angle iron and the pole from a hardware store, i believe it was menards.

    derek posted

  • How much did this project cost?

    Derek posted

  • How much did the coping cost? It seems like all the metal i can find for coping is sort of expensive.

    David posted

  • how much did it cost

    jeffrey dahmer posted

  • was this easy to make? i want to make one

    alex posted

  • ya how much did this cost?

    alex posted

  • did u use 2 sheets of 5 ply OR 1 sheet of 7 ply

    LP posted

  • HOW MUCH DID THE ENTIRE THING COST TO MAKE, AND IS THERE SUPPORTS On THE INSIDE OF THE BOX, OH HOW ABOUT THIS....?

    kody posted

  • how wide is it?

    joe posted

  • how wide is it?

    joe posted

  • all of these questions are basically answered here: derek.broox.com/phot...e-box/

    derek posted

  • wat does it mean wen it says 5-21ft 2x4

    adam posted

  • 21 inch, not feet.

    cut 5 2x4s into 21 inch long pieces.

    derek posted

  • its too small to the ground nothing like filming is gonna look good with that its like a curb

    james posted

  • how much did it cost?

    josh posted

  • gay

    james posted

  • how do u mke it

    ben posted

  • where do u get the angled metal? and how much was the angled metal?

    Collin Bogie posted

  • i just got it at a hardware store - menards or home depot should both have it.

    derek posted